His tone is incredible and he is capable of an extreme vibrato that is perfect for his style of playing. It’s obvious he’s not working hard for it. His choices of strings benefit his economy of motion. Even though he maintains low action on his Fender Stratocasters and even scallops the frets for acrobatic, tight-rope string walking, his ability is only strengthened by the ease of playing light string gauges.
Some guitarists and guitar makers avoid this by including an additional resistor, around 4.7kOhms, in series with the capacitor. This provides a minimum level of resistance, so the tone circuit is never at “zero” even when the knob indicates it. You can see in the chart that around 4kOhms (about “1” on the tone pot knob), there’s no hump in the midrange, just a very rapid falloff in the upper mids and treble frequencies.
I skimmed ahead and quickly realized that, at last, someone has written THAT GUITAR BOOK that we are all looking for when we start out but that no one seems to have written yet but that you hope to write someday when you finally figure out what you are doing so that you can help others and prevent them from wasting so much time and money and hopes....(takes a breath)
When Leo and the boys at the big “F” ranch developed the Tele, they put a big slab of steel under the bridge-pickup coil. This reflected the magnetic field up and toward the strings. In the words of Seymour Duncan’s Evan Skopp, this gives it more “crack”—which, if you’re addicted to twang, is a good thing. The better news is that you can attach a plate (sometimes called an elevator plate, because of how it elevates the magnetic field toward the strings) to any single coil whose pole-piece magnets are exposed at the back.
Though the guitar is played through an amplifier which is often miked and recorded, the engineer or producer may later decide to use a different amplifier tone that's better suited to the character and timbre of the song, while preserving all the nuance and inflection of the original performance embedded in the direct track. The re-amp device allows the dry track to be sent to an amplifier again and properly miked and re-recorded for use as the final track.