Mic orientation, or the angle of the mic in relation to the speaker, becomes more critical as the mic is moved closer to the amp. Pointing the mic at the center of the cone will yield more active highs and better transient detail but fewer lows. As you move the mic toward the outer rim of the speaker, maintaining a 90-degree angle with the grille cloth, the low frequencies gradually increase because of proximity effect and other factors, resulting in a sound that may be warmer, softer, or more powerful. Many engineers like to blend these complex characteristics by angling the mic between 30 and 60 degrees off-axis from the center of the speaker.
The ’37 Hawaiian Guitar in both the Sorkin and Grossman books was basically the same squarish, pear-shaped guitar as in ’36, sans pickguard. It had a polished Ebonoid fingerboard with new parallelogram position markers replacing the old dots. Also, the large, two-part rectangular pickup cover/tail assembly was replaced with a more conventional, modern design. The pickup cover was the new rectangular type with the two pole extensions exposed. Off to the side of its surround was a little square plate on the treble side containing the volume control. The strings attached to a small piece of slotted metal hidden under a rectangular cover or “handrest.” Gone were the control wings. The microphone attachment stuck out the bass side of the guitar. The cost was $35, plus $6 for a case.
This open-C tuning gives the initial harmonic series when a C-string is struck. The C-C-G-C-E-G tuning uses the harmonic sequence (overtones) of the note C. When an open-note C-string is struck, its harmonic sequence begins with the notes (C,C,G,C,E,G,B♭,C). This overtone-series tuning was modified by Mick Ralphs, who used a high C rather than the high G for "Can't Get Enough" on Bad Company. Ralphs said, "It needs the open C to have that ring," and "it never really sounds right in standard tuning".
There are different ways to play electric guitar. One is to just play the electric guitar, and to take it as it is. Another way is to play the guitar as a sort of synthesizer. With the right effects (delay, reverb, volume swells, added octaves), no one would even know that it was a guitar. Neither way is wrong, but we refer to both as "playing electric guitar" even though they're being used in completely different ways that may as well be different instruments. Drama ensues.
Taylor 110ce Yes, there’s already one Taylor in the list, but we just can’t resist including the Taylor 110ce dreadnought. It certainly deserves a spot here because of its noteworthy qualities, which include a thin-profile neck, shorter nut width, well-balanced tone and plenty of projection. Plugged in, the guitar produces a natural electro-acoustic sound - just the way we like it.
While it is possible to practice on a huge stack, it’s more convenient (and probably more sensible) to practice on a compact, low-powered, versatile practice amp. These little combo amps are one of the most important tools in a guitarist’s tool box, especially for beginners who should avoid ‘dry practice’ (i.e. without an amp) as it encourages bad habits. Many amps can be considered a practice amp, but one of our favorites is the Fender Frontman 10G – a very affordable practice amp that offers 10 watts of power, solid Fender tone and a headphone jack for quiet practice sessions.
This Duo-Jet has the typical brown back and neck finish, original tuners, bone nut (which has never been off), ebony fingerboard and original frets, lefty thumbprint inlays, original Pat. Applied For Filter’Tron pickups with original wire harness including switches and capacitors. All solder joints are original. Original bar bridge. The lefty Bigsby tailpiece does not appear to be original to the instrument, and is probably a late 60s Bigsby, as there are screw-holes from another tail-piece on the bottom. The second to most recent owner acquired the guitar with its current tailpiece in 1971, and the only change he made to the Bigsby was in removing the black paint. The guitar was recently sent to Curt Wilson at Old School Guitar Repair(www.oldschoolguitar.net) at the recommendation of Gretsch guru, Edward Ball, where the front of the headstock was refinished to the correct black(previously Orange) and the center portion of the Bigsby was repainted black. Sadly, the previous owner removed and discarded the original lefty pickguard many years ago.
The musical theory of chords is reviewed, to provide terminology for a discussion of guitar chords. Three kinds of chords, which are emphasized in introductions to guitar-playing, are discussed. These basic chords arise in chord-triples that are conventional in Western music, triples that are called three-chord progressions. After each type of chord is introduced, its role in three-chord progressions is noted.
Here we are proud to have in stock today is a Cool one she's pretty rare too its a real vintage guitar its actually 42year old in fact. This is a great old Vintage Goya Acoustic Dreadnought Guitar by CF Martin & company. This guitar was built in the early 1970s in Japan when Martin had thought that it was a good way to address the Japanese high quality lower priced Japanese guitars cutting into their bottom line so Martin commissioned Goya of Japan to build their competitive to the US line "import" line ( Japan because no other country at that time was building anything close to the high quality guitars like Japan was making " China , India, Twain was not even a consideration Japan was in another league obviously to those countries... so Goya was commissioned back in the day this pre dates Sigma Japan... This was built durring the time frame when the Japanes builders had some of the best quality woods available to them and were setting out to show the world what they could really do. This is a great example with both fine quality qoods used from the high grade mahogany to the solid spruce top to the rich dark Brazilian rosewood looking fingerboards they selected wow impressive work...Kept in great shape all these years 42 years see the pics it looks more like its 3 years old then 42... here today for a song we believe this example was built in Nagoya by the great Terada, that is pretty much the Custom shop builders in Japan they are responsible for the GB10 George Benson Ibanez line, They made the high end Ibanez Artists, The Gretch reissues, some other fine models as well as their own Tereda guitars. On to this baby The top is book matched SOLID AAA Spruce and the sides and back are mahogany, probably laminated but they seam to match?. either way *AWESOME* The SB model has a beautiful transparent cherry sunburst finish that is still so glossy looking it can pass for much newer but its 36 years old!. The Neck is also solid AAA mahogany with a beautiful rich looking rosewood fingerboard may be Brazilian Rosewood . The neck is RARE with a nicely v shaped which feels really good to me I think you'll be please with the feel as well. Setup done by our in house luthier & plays like butta now with a new set of acoustic Martin 11's, a $150 value. Now how ya gonna beat that! .
Does anyone have one of either of these that they can comment on? I dig the looks of the silverburst (though I also dig the cream/ivory colored ones), and kinda want to have an SG in my posession (thanks to Zappa!). I have read all the positive reviews of Agiles on here, but few mention the Valkyrie...I'm a little worried that it is in the lower end of their price range, so I'm wondering how the hardware/electronics/fit and finish are....I'm aware it's not going to be crazy high end, but I'd like it to be useable (even though I may swap out some parts). Any opinions? Also, what parts would you recommend swapping out? Would an Epiphone be a better deal in terms of fit and finish and stock parts?
The Supro aluminum Hawaiian lap steel was similar to Beauchamp/Electro’s “frying pan,” with a round body and guitar-like neck, very similar to the Rick, but with the top carved away to allow a little more access. Given the close nature of the L.A. guitar world, it’s entirely possible that all these aluminum guitars were cast at the same place. The head was three-and-three with a single cutout in the middle. The Supro had dot inlays on the fingerboard, with an alternating two/one pattern and four dots at the octave. A rectangular Supro logo plate sat between the pickup cover and the fingerboard. The pickup – the single-coil version of the Stimson design – was mounted under a raised cover (part of the casting) with a slit to reveal the bar polepieces. It had one volume knob on the treble side and was housed in small form-fit hardshell case. This was closest to Beauchamp’s patented electro guitar design, making the Supro brand a direct descendent of George Beauchamp. An important point to remember is that these cast aluminum guitars were made in Los Angeles.
Audiffex Guitar Pedals was one of the first professional guitar software packages, with its original version released more than a decade ago. It has since been upgraded but continues its legacy of providing stompbox effects in software form. The latest version is an all in one guitar effects software package - which includes 36 plug-ins that also works for bass, vocals and other instruments. Features include consistent interface with all effects having similar controls, modular plug-in configuration for easier and flexible routing and intuitive preset management. Current retail price: $49
For acoustic guitar players (and electric players) there is simply nothing to dislike about the Hall of Fame reverb pedal, unless you just dislike ambient effects in general. The HOF is one of the most well-put together ambient stompboxes we've ever used, and it's perfect for acoustic guitar tones. When you're adding effects to your acoustic guitar, reverb is one of the best suitors for several reasons.
Overdrive pedals are very different to distortion pedals, and without getting too technical, they drive/push your guitar signal harder rather than changing the sound completely like a distortion pedal does. An overdrive pedal retains a lot of the original sound of your guitar and amp but pushes the amplifier harder to give it a heavier, thicker signal. They’re ideally used with valve/tube amps as they push the tubes to their limit and allow them to bring out the more natural distortion that tube amps are so renowned for. Incidentally, we wrote about the best tube amps for home use here, but if you wanted some great practice amps, we also wrote about them here too!
Straight away meeting the essential criteria and tonal platform for a good small solid state combo amp for practicing at low volumes with a pocket friendly price tag is Orange Crush 20RT. This dual channel 20 watt guitar amplifier that also comes in a 35 watt version is the upgraded model of the well received Orange Crush 20 for having a built-in spring reverb effect and a chromatic tuner which are the kind of features great for daily use.
WoW Talk about nailing the essence of the Original by Gibson.... This is a well crafted Japanese Prime Lawsuit era Classic with the great looks and BIG fat TONE is what this old vintage Japanese script logo Alvarez J200 guitar has to over you today nearly 40 years ago and a true Japanese Vintage work of art really. Beautiful Headstock with Alvarez Script logo in mother of pearl inlay with crown as well is its original truss rod cover is striking.Overall The fit and finish is hard to beat the materials are superior grain looks as is fit and finish and she has stood the test of TIME. Minor Vintage checking seen on its top and only adds realism to its true vintage status no reduction from its appeal its very cool looking as you can see from its pictures even perhaps more beautiful than the 70]s Gibson from this same era this Alvarez is based on the early1960's era known to be the preferred vintage era to own amongst the Gibson aficionados This is a prime example and is overall GREAT with super easy low action we completely cleaned this instrument upon its arrival it was owned by a smoker and needed it but never abused luckily then we dressed the frets and polished the entire guitar and frets as a result it looks this amazing and I have seen every square inch and can tell you this is a very good example from my inspection while working on it. She plays really nice now, with very good volume and a rich vintage 40 year old Vintage Alvarez kind of tone I expect from a good J200... This guitar has that, No brakes no repairs non needed no reason this vintage Japanese Lawsuit J200 should easily play another 40 years with good care she's set up and playing Amazingly.... SUPER FUN to play Act quick our last Alvarez 5052 Script logo went pretty fast... She's here and available and in stock.... email Joe to buy it NOW: JVGuitars@gmail.com .
During the NSF grant cycles, the STEM Guitar Project has exceeded initial estimates of faculty impacted by recruiting over 450 STEM educators, with an additional 500 faculty exposed via national education conferences. Thus far, this effort is impacting over 20,000 students nationally over the 8 years because of faculty members adopting or adapting the curriculum developed through the project.
Large speaker cabinets such as 8x10" enclosures may have wheels and a "towel bar" and dolly wheels to facilitate transportation. Speaker cabinets with 1/4 input jacks typically have two parallel jacks, so that the amp head may be plugged into one cabinet, and then a second cabinet can be "daisy chained" by connecting it to the first cabinet. Cabinets with horn-loaded tweeters often have an attenuator knob for controlling the tweeter. Some 2000s-era speaker cabinets may have Speakon jacks; these jacks are often used with high-wattage amps, because they are safer, as the cable connections are hidden inside the connector and thus it is impossible for the user to touch the metal contacts when plugging in the amp cable.
Perhaps the most dramatic of ambient mic techniques, though, comes courtesy of Chris Tsangarides. His 'Vortex' involves using studio screens to build 30-foot-long walls along each side of the guitar cabinet, creating a flare shape (apparently inspired by the shape of a bass bin). Within this flare, he places a close condenser mic and typically another couple of condenser mics with different distant positionings, perhaps at 15 and 30 feet away. "I walk around while the guy's playing and find a sweet spot and put the mic there", says Chris.